Back to Blog
How-to Guides 2026-11-18 Portable Power Stations, Solar Generators 0 views

TORCH 250 Flashlight: Runtime, Charging, and Care FAQ

TORCH 250 Flashlight: Runtime, Charging, and Care FAQ

How long the TORCH 250 runs, how to charge it by USB, sun, or crank, and what its care record actually says—answered from the supplied specs.

TORCH 250 runtime and light modes

How long does the TORCH 250 run on a full charge?
Runtime depends on the mode. The record lists spot light at 15 hours on low and 7 hours on high, and flood light at 48 hours on low and 22 hours on high. The 250-lumen LED output is the headline figure; spot and flood are listed separately at 180 and 70 lumens.
What is the difference between spot, flood, and red light?
The TORCH 250 is designed as a flashlight, floodlight, or red emergency light, with bright and half-bright modes to save power. Spot is the focused beam; flood spreads light for a wider area; red is intended for emergencies.
How much light does one minute of hand cranking give?
The record states 1 minute of cranking at 120 RPM produces about 2 minutes of light. The crank is rated 2.2W, so treat it as a top-up for short bursts rather than a full recharge.

How to charge the TORCH 250

How do I charge the TORCH 250 from USB?
Use the built-in USB charging cable. The record gives a USB source charge time of about 5 hours in the charge-times section, while another line describes a USB recharge in about 7 hours. The input port is rated 5V up to 1A (5W max), so a standard 5V USB source is the match.
Can I charge it with the built-in solar panel?
Yes—the solar panel is on the back of the light. The record lists built-in solar charge time as 23–46 hours, which makes it a slow, weather-dependent option rather than a quick top-up.
What does a larger solar panel change?
The record says you can connect a larger solar panel such as the Nomad 7 and recharge in about 7–14 hours. That is still a sun-dependent process, so plan around available daylight.
When would I use the hand crank?
The record describes the crank as an in-a-pinch option: 1 minute of cranking can generate about 2 minutes of light. It is not listed as a full-recharge method.

Specs that shape daily use

  • TORCH 250 FLASHLIGHT: Weight: 14.4 oz (408 g); Dimensions: 10 x 3.5 x 1.75 in (25.4 x 8.9 x 4.5 cm) At roughly a pound and ten inches long, it is a pack-or-shelf light rather than a pocket carry.
    TORCH 250 FLASHLIGHT
    TORCH 250 FLASHLIGHT
  • TORCH 250 FLASHLIGHT: USB port (output): 5V, up to 1A (5W max), regulated The output is for charging a phone or boosting a tablet, but the 5W ceiling sets expectations for how fast that will go.
  • TORCH 250 FLASHLIGHT: Operating Useage Temp: 32-104 F (0-40 C) This is the supplied operating range; keep the light within it rather than guessing at cold-weather performance.
  • TORCH 250 FLASHLIGHT: Warranty 12 months A one-year warranty is the stated coverage period in the record.

Battery care and storage

How often should I recharge the TORCH 250 in storage?
The record lists a shelf life instruction: charge every 3–6 months. That is the supplied battery-care guidance for keeping the light ready between uses.
What battery does it use, and does it have protection?
The cell is Li-NMC with a 16.3 Wh capacity (3.7V, 4400mAh) and hundreds of listed lifecycles. The management system includes charging and low-battery protection built in.
Does the record give cleaning or waterproofing instructions?
No cleaning procedure or water-resistance rating appears in the supplied record. The construction is described as durable and rugged, but that is not a protection rating, so do not treat it as one.

Emergency setup and compatibility

What should I check before relying on it in an outage?
Confirm the battery is charged per the 3–6 month shelf-life guidance, know where the built-in USB cable and solar panel are, and practice switching to red light so you are not learning the controls in the dark.
Can I chain it to another light or power source?
The record lists Chainable: No. Plan it as a standalone light rather than part of a linked lighting setup.
Can it charge my phone?
Yes—the integrated USB output port is intended to charge phones and boost tablets. The output is regulated at 5V up to 1A (5W max), so it is a modest emergency top-up, not a fast charger.

Related Articles

Customer Service
Home
Products
Cart
Profile