Boulder 100 Solar Panel Mountable Bundle Setup Guide

Quick Answer

Set up your Boulder 100 Solar Panel Mountable Bundle by mounting the panels, connecting them with the included Combiners, and linking to your Yeti 3000X via the 30 ft. High Power Port Extension Cable.

Setup Steps

1. Mount the Panels: Attach the included mounting brackets to your roof or ground rack using the provided hardware. Position each Boulder 100 panel so the kickstand can still adjust the tilt angle. Secure the panels to the brackets with the bolts supplied. Common mistake: Over-tightening bolts can crack the panel frame. Tighten to hand-tight plus a quarter turn.
2. Connect Panels with Combiners: Use the included Combiners to link the six panels in parallel. Each Combiner accepts two panel outputs; connect them in sequence until all panels are joined. Ensure all connections are dry and fully seated to prevent voltage drop. Checkpoint: Verify the polarity of each connection—reversing a cable can damage the panels or the power station.
3. Run the Extension Cable: Connect the 30 ft. High Power Port Extension Cable from the Combiner output to your Yeti 3000X. Route the cable away from sharp edges or moving parts. Use cable clips to keep it secure and out of foot traffic. Common mistake: Coiling excess cable tightly can cause overheating. Leave it loosely laid out.
4. Connect to the Yeti 3000X: Plug the extension cable's High Power Port connector into the Yeti 3000X's solar input. The power station will automatically detect the panels and start charging. Check the display to confirm input voltage (expect 14-22V per panel, combined in parallel). Checkpoint: If the Yeti shows no input, verify the cable is fully inserted and the panels are in direct sunlight.
5. Test and Adjust: After initial connection, monitor the Yeti 3000X display for a few minutes to ensure steady charging. Adjust panel tilt angles seasonally for best sun exposure. Clean the panels with a soft cloth and water as needed. Common mistake: Ignoring shading—even partial shade on one panel can reduce the whole array's output. Trim nearby branches or relocate panels if necessary.

Product Spotlight

• (6) Boulder 100 Solar Panel Mountable Bundle: The bundle includes six Boulder 100 panels with integrated kickstands, Combiners for easy panel connection, and a 30 ft. High Power Port Extension Cable. The kickstands let you angle panels for best sunlight without extra hardware, while the Combiners simplify wiring so you don't need a separate junction box.